ZH
INSTALLATION
1. Position the new output shaft seal over the output
shaft and against the transmission case (2).
2. Use Special Tool 8902A (1) to install the seal.
3. Install the propeller shaft flange onto the output
shaft.
4. Place the transmission in the PARK position before
attempting to tighten the output shaft nut.
5. Install a new output shaft nut. Tighten the output
shaft nut to 120 N·m (88.5 ft. lbs.).
6. Stake the output shaft nut to the output shaft as follows.
a. Place the Special Tool 9078 (2) and Special
Tool C-4171 onto the output shaft.
b. Rotate the Special Tool 9078 (2) until the align-
ment pin (3) engages the output shaft notch
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 331