Chrysler 2005 Crossfire SRT6 Service Manual page 3031

ZH
INSTALLATION
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM
BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, DRIVER AIRBAG, PASSENGER AIR-
BAG, FRONT IMPACT SENSOR, SIDE IMPACT SENSOR, SIDE CURTAIN AIRBAG, OR INSTRUMENT PANEL
COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND)
CABLE, THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING
FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL
RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL
AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
WARNING: WHEN REMOVING A DEPLOYED AIRBAG, RUBBER GLOVES, EYE PROTECTION, AND A LONG-
SLEEVED SHIRT SHOULD BE WORN. THERE MAY BE DEPOSITS ON THE AIRBAG CUSHION AND OTHER
INTERIOR SURFACES. IN LARGE DOSES, THESE DEPOSITS MAY CAUSE IRRITATION TO THE SKIN AND
EYES.
CAUTION: If the steering wheel is offset by more than 1 tooth, the turn signal indicator is no longer properly
aligned.
CAUTION: The SRS Malfunction Indicator Lamp must not come on at full steering lock in either direction.
CAUTION: If the steering wheel is not on straight, offset it by a maximum of 1 tooth, if the difference is
greater, check and adjust the front wheel toe-in.(Refer to 2 - SUSPENSION/WHEEL ALIGNMENT - SPECIFI-
CATIONS).
1. Align the recesses of the splines in the steering
wheel with the markings on the steering shaft.
2. Install the tapered steering wheel bolt (1). Tighten
to 80 N·m (60 ft. lbs.).
COLUMN 19 - 31