Chrysler 2005 Crossfire SRT6 Service Manual page 3303

ZH
9. Securely tighten the multi-disc holding clutch B1 (5) on the converter housing (2) to 10 N·m (88.5 in. lbs.).
10. Install a new torque converter hub seal (1) into
the oil pump using Special Tool 8902A.
11. Install a new oil pump outer o-ring seal (2) onto
the oil pump.
12. Install the oil pump (6) and securely tighten.
Tighten the oil pump bolts to 20 N·m (177 in. lbs.).
13. Using grease, insert the teflon rings (7) in the groove so that the joint remains together.
14. Install the driving clutch K1 (1) onto multi-disc holding clutch B1.
15. Install the drive shaft with driving clutch K2 (6) and front planetary gear set (1).
16. Install the front washer (5) and the thrust needle bearing (4).
17. Install the output shaft with the center and rear planetary gear set and driving clutch K3 (3).
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 233