Chrysler 2005 Crossfire SRT6 Service Manual page 3373

ZH
12. Install the electrohydraulic control module (12)
onto the shift plate (13).
13. Bend the retaining lug on the stiffening rib on the
transmission oil temperature sensor to retain the
electrohydraulic control module.
14. Install the solenoid valves (6 - 11) into the shift
plate (13).
Note: Check the O-rings on the solenoid valves for
damage and replace if necessary.
15. Install the leaf springs (5).
16. Install the bolts (3, 4). Tighten the bolts to 8 N·m
(71 in. lbs.).
Note: Pay attention to the different lengths of the
bolts.
17. Install the solenoid caps (1, 2).
18. Install the electrohydraulic unit into the vehicle. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC -
NAG1/ELECTROHYDRAULIC UNIT - INSTALLATION).
INSTALLATION
1. Position the electrohydraulic unit in the transmis-
sion housing.
2. Insert the selector valve (1) in the driver of the
detent plate (2). When installing the electrohydrau-
lic control module in the transmission housing, the
plastic part of the selector valve (1) must engage in
the driver of the detent plate (2).
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 303