Chrysler 2005 Crossfire SRT6 Service Manual page 3489

ZH
NO TIRES TRAINED (CONTINUED)
When Monitored And Set Condition
• When Monitored: With the ignition on, the Tire Pressure Monitor (TPM) monitors the tire pressure sensor/trans-
mitters approximately once a minute (60 – 68 seconds) when the vehicle speed is above 33 km/h (20 MPH).
• Set Condition: If the Tire Pressure Monitor (TPM) module does not receive a signal from any tire pressure
sensor/transmitter, the DTC will be set.
INITIALIZATION FAILURE
TIRE TRAINING TIMEOUT
NO TRANSMITTER ID SET IN MEMORY
For a complete Tire Pressure Monitor Circuit Diagram (Refer to 22 - TIRES/WHEELS - SCHEMATICS AND DIA-
GRAMS)
Diagnostic Test
1.
PROGRAMMING TIRE PRESSURE MONITOR
Turn the ignition on.
With the DRB III and a calibration magnet, program the Tire Pressure
Monitor module for all four tire pressure sensor/transmitters.
Disconnect the DRB III and prepare the vehicle for a road test.
Road test the vehicle above 33 km/h (20 MPH) for a minimum of two
minutes.
With the DRB III read the last 32 transmissions received by the Tire
Pressure Monitor.
Does the DRB III display any of the tire pressure transmitter
IDs in the last 32 transmissions?
Yes >> Repair is complete.
Perform TIRE PRESSURE MONITOR VERIFICATION
TEST.
No >> Replace and program the Tire Pressure Monitor module.(Refer to 22 - TIRES/WHEELS/TIRE PRES-
SURE MONITORING/MODULE - REMOVAL)
Perform TIRE PRESSURE MONITOR VERIFICATION TEST.
TIRES/WHEELS - ELECTRICAL DIAGNOSTICS 22 - 3
POSSIBLE CAUSES