ZH
(P0600) SLA CAN MESSAGE INCORRECT (CONTINUED)
2.
CHECK TO SEE IF (P0720) CAN BUS CIRCUIT DTC PRESENT
Turn the ignition on.
With the DRB III , read Transmission DTCs.
Note: If DTC (P0720) CAN BUS CIRCUIT is present, perform diag-
nostics on that symptom first.
Is DTC (P0720) CAN BUS CIRCUIT present?
Yes
>> Refer to the Transmission - Electrical Diagnostics category
and perform the appropriate symptom.
No
>> Go To 3
3.
CHECK TO SEE IF SHIFT LEVER DTC PRESENT
With the ignition on.
With the DRB III , read Shift Lever Assembly DTCs.
Are any Shift Lever Assembly DTCs present?
Yes
>> Refer to the Shift Lever Assembly category and perform
the appropriate symptom.
No
>> Go To 4
4.
CAN C BUS (+) OR (-) CIRCUIT(S) OPEN
Turn the ignition off.
Disconnect the Shift Lever Assembly harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance from the CAN C BUS (+) circuit to the CAN C
BUS (-) circuit at the Shift Lever Assembly harness connector.
Is the resistance 60 ohms ± 3.0 ohms?
Yes
>> Replace the Shift Lever Assembly. (Refer to 21 - TRANS-
MISSION/TRANSAXLE/AUTOMATIC
MECHANISM - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No
>> Repair the faulty CAN C BUS circuit for an open.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
NAG1 - ELECTRICAL DIAGNOSTICS 21 - 67
-
NAG1/SHIFT