Chrysler 2005 Crossfire SRT6 Service Manual page 3400

21 - 330 AUTOMATIC - NAG1 SERVICE INFORMATION
7. Stake the output shaft nut to the output shaft as
follows.
a. Place Special Tool 9078 (2) and Special Tool
C-4171 onto the output shaft.
b. Rotate Special Tool 9078 (2) until the align-
ment pin (3) engages the output shaft notch
(4).
c. Press downward on Special Tool 9078 (1) until
the staking pin (3) contacts the output shaft nut
flange (2).
d. Strike the Special Tool C-4171 with a suitable
hammer until the output shaft nut is securely
staked to the output shaft.
8. Install the propeller shaft. (Refer to 3 - DIFFEREN-
TIAL & DRIVELINE/PROPELLER
INSTALLATION).
OUTPUT SHAFT SEAL
REMOVAL
1. Remove the propeller shaft. (Refer to 3 - DIFFERENTIAL & DRIVELINE/PROPELLER SHAFT - REMOVAL).
Move propeller shaft to the right and tie up.
2. Place the transmission in the PARK position before attempting to remove the output shaft nut.
3. Remove the output shaft nut holding the propeller shaft flange to the output shaft.
4. Remove the propeller shaft flange.
5. Remove the output shaft seal with suitable screw and slide hammer.
SHAFT -
ZH