Chrysler 2005 Crossfire SRT6 Service Manual page 3342

21 - 272 AUTOMATIC - NAG1 SERVICE INFORMATION
a. Mount Special Tool 8901 (1) on the K1 outer
disc carrier (2).
b. Using a lever press, compress the pressing
tool as far as the stop (then the marking ring is
still visible, see small arrow).
c. Using a feeler gauge, determine the play "L" at
three points between the snap-ring (6) and
outer multiple-disc (3).
d. During the measurement, the snap-ring (6)
must contact the upper bearing surface of the
groove in the outer multiple-disc carrier.
e. The correct clutch clearance is 2.7-3.1 mm
(0.106-0.122 in.) for three friction disc versions,
3.0-3.4 mm (0.118-0.134 in.) for four disc ver-
sions, 3.3-3.7 mm (0.130-0.146 in.) for five disc
versions, and 3.6-4.0 mm (0.142-0.158 in.) for
six disc versions.
f. Adjust with snap-ring (6), if necessary. Snap-
rings are available in thicknesses of 2.6 mm
(0.102 in.), 2.9 mm (0.114 in.), 3.2 mm (0.126
in.), 3.5 mm (0.138 in.), 3.8 mm (0.150 in.), and
4.1 mm (0.162 in.).
ZH