ZH
9. Invert the mainshaft with input shaft in the vise.
Use protected vise jaws.
10. Install the second gear needle bearing (3), and
second gear (2) on the mainshaft (1) with the col-
lar facing upwards.
11. Install the friction ring (4), the cone ring (3), and
the synchronizer ring (2). The lobes in the friction
ring (4) must engage in the recesses of the syn-
chronizer ring (3).
12. Assemble the 1st/2nd gear synchronizer if it is not being replaced. (Refer to 21 - TRANSMISSION/TRANS-
AXLE/MANUAL/SYNCHRONIZER - ASSEMBLY).
MANUAL - SERVICE INFORMATION 21 - 393