19 - 64
LINKAGE
5. Using Special Tool 9168 (2) remove the drag link
(1) from the pitman arm and the idler arm.
6. Inspect the tie rod ends for play or damage. Repair
as necessary.
INSTALLATION
INSTALLATION
1. Clean any grease or debris from the tie rod ends,
and the drag link attaching points (1).
2. Install the drag link and the attaching nuts (1) to
the idler arm and pitman arm. Tighten the drag link
nuts to 50 N·m (37 ft. lbs.).
3. Install the tie rod ends into the steering knuckles.
4. Install the nuts on the tie rod ends. Tighten to 50
N·m (37 ft. lbs.).
5. Install the steering dampener. Tighten to 40 N·m
(29 ft. lbs.).
6. Adjust the front toe setting on the vehicle. (Refer to
2 - SUSPENSION/WHEEL ALIGNMENT - STAN-
DARD PROCEDURE).
ZH