Chrysler 2005 Crossfire SRT6 Service Manual page 3306

21 - 236 AUTOMATIC - NAG1 SERVICE INFORMATION
25. Measure the input shaft end-play.
Note: If the end-play is incorrect, the transmission
is incorrectly assembled, or the geartrain end-play
shim is incorrect. The geartrain end-play shim is
selective.
a. Attach Special Tool 8266-18 (2) to Special Tool
8266-8 (1).
b. Attach Special Tool C-3339 (3) to Special Tool
8266-8 (1).
c. Install the assembled tool onto the input shaft
of the transmission and tighten the retaining
screw on Special Tool 8266-18 (2) to secure it
to the input shaft.
d. Position the dial indicator plunger against a flat
spot on the oil pump and zero the dial indica-
tor.
e. Move the input shaft in and out and record reading. End play should be 0.3-0.5 mm (0.012-0.020 in.). Adjust
as necessary.
26. Install the output shaft washer onto the output shaft.
27. Install a new transmission rear seal into the trans-
mission case (2) with Special Tool 8902A (1).
28. Install the propeller shaft flange onto the output
shaft.
29. Place the transmission in the PARK position
before attempting to tighten the output shaft nut.
30. Install a new output shaft nut. Tighten the output
shaft nut to 120 N·m (88.5 ft. lbs.).
ZH