Chrysler 2005 Crossfire SRT6 Service Manual page 3157

ZH
(P0710) TRANS TEMP SENSOR SHORTED (CONTINUED)
3.
TRANSMISSION TEMPERATURE SENSOR
Turn the ignition off.
Disconnect the TCM C2 harness connector.
Note: Check connectors - Clean/repair as necessary.
Place the gear selector in Drive.
Measure the resistance of the Transmission Temperature Sensor from
the Temp Sensor - P/N Switch circuit to the Sensor Ground circuit at
the TCM C2 harness connector.
Is the resistance between 500 ohms and 2500 ohms?
Yes >> Replace the Transmission Control Module. (Refer to 8 -
ELECTRICAL/ELECTRONIC
TRANSMISSION CONTROL MODULE - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Check for a poor terminal to pin connections at the Trans-
mission Solenoid Assembly harness connector and repair
as necessary. If no problems are found in the connector,
replace the Transmission Temperature Sensor - P/N Switch. (Refer to 21 - TRANSMISSION/TRANS-
AXLE/AUTOMATIC - NAG1/ELECTROHYDRAULIC UNIT - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
4.
TRANSMISSION TEMP SENSOR - P/N SWITCH
Turn the ignition off.
Disconnect the Transmission Solenoid Assembly harness connector.
Note: Check connectors - Clean/repair as necessary.
Note: This procedure may set several DTCs in both the PCM and TCM. Disregard and erase DTCs after this
procedure.
With the gear selector in park, attempt to start the engine.
Does the engine start?
Yes >> Replace the Transmission Temperature Sensor - P/N Switch Assembly. (Refer to 21 - TRANSMISSION/
TRANSAXLE/AUTOMATIC - NAG1/ELECTROHYDRAULIC UNIT - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Go To 5
NAG1 - ELECTRICAL DIAGNOSTICS 21 - 87
CONTROL MODULES/