ZH
INSTALLATION - RHD
1. Clean any grease or debris from the tie rod ends,
and the drag link attaching points (1).
2. Install the drag link and the attaching nuts (1) to
the idler arm and pitman arm. Tighten the drag link
nuts to 50 N·m (37 ft. lbs.).
3. Install the tie rod ends into the steering knuckles.
4. Install the nuts on the tie rod ends. Tighten to 50
N·m (37 ft. lbs.).
5. Install the steering dampener. Tighten to 40 N·m
(29 ft. lbs.). (Refer to 19 - STEERING/LINKAGE/
DAMPER - INSTALLATION).
6. Adjust the front toe setting on the vehicle.
TIE ROD END
REMOVAL
1. Loosen the tie rod end jam nut (1).
2. Remove nut from the tie rod end at the steering
knuckle.
3. Using Special Tool C-3894-A (2) two jaw puller
remove the tie rod end (1) from the steering
knuckle.
4. Unscrew the tie rod end from the drag link.
LINKAGE 19 - 65