Chrysler 2005 Crossfire SRT6 Service Manual page 3883

23 - 322 EXTERIOR
5. While the retaining clip is compressed, carefully
pull the end of the louver and release the louver
from the fender.
6. Repeat the prior steps in order to release the
remaining louvers (three total).
7. Carefully pull the entire louver assembly away from
the fender, with the front edge acting as a hinge.
8. Remove the louver from the fender.
INSTALLATION
1. Inspect the fender for any remaining adhesive and
remove any old adhesive.
2. Prep the painted surface for the application of the
new louver adhesive strips.
Note: Use a commercially available and approved
Wax and Grease remover to prep the painted
surface.
ZH