Chrysler 2005 Crossfire SRT6 Service Manual page 3936

ZH
4. Install the screw (2) attaching the lower I/P panel to
the cluster bezel.
5. Install the illumination control module into the I/P,
then connect the illumination control module har-
ness connector.
6. Install the two screws (4) attaching the lower I/P to
the illumination control module and the screw (3)
on the side of the I/P to the illumination control
module support bar.
7. Install the fuse panel side cover.
8. Install the steering column panel then install the
screw (5) attaching the steering column panel
under the steering column.
9. Install the right side I/P air outlet deflector (1).
INSTALLATION - INSTRUMENT CLUSTER COVER
1. Tip the instrument cluster cover toward the rear at
the top, then lift it over the jacket tube covering and
simultaneously guide the adjustment knobs through
the cover.
2. Connect the instrument cluster cover (1) to the
instrument panel top section.
3. Install the screws attaching the instrument cluster
cover to the lower instrument panel.
4. Install the sentry key antenna ring to the key cylin-
der.
5. Install the lower instrument panel. (Refer to 23 -
BODY/INSTRUMENT
PANEL ASSEMBLY - INSTALLATION).
6. Install the steering wheel. (Refer to 19 - STEER-
ING/COLUMN/STEERING
INSTALLATION).
PANEL/INSTRUMENT
WHEEL -
INSTRUMENT PANEL 23 - 375