Chrysler 2005 Crossfire SRT6 Service Manual page 3950

ZH
11. Install the paneling (2) in the left footwell.
12. Install the door sill trim plate (4). (Refer to 23 -
BODY/INTERIOR/DOOR SILL TRIM PLATE -
INSTALLATION). Install the edge guard (1) in the
area of the paneling (2). Install the screw (3), then
install the cap.
13. Install the air outlet cover in the footwell.
14. Install the ashtray housing with the stowage com-
partment in the front of the center console. (Refer
to 23 - BODY/INTERIOR/CENTER CONSOLE -
INSTALLATION).
15. Install the cover on center console. (Refer to 23 -
BODY/INTERIOR/CENTER CONSOLE - INSTAL-
LATION).
16. Install the rear center console. (Refer to 23 -
BODY/INTERIOR/CENTER CONSOLE - INSTAL-
LATION).
17. Install the front seat. (Refer to 23 - BODY/SEATS/
SEAT - INSTALLATION).
INSTALLATION - CARPET (RIGHT SIDE)
Note: Before installing floor covering, clean vehi-
cle passenger compartment in area of floor cover-
ing.
1. Prepare the carpet (1) for installation. Cut the new
carpet (1) along the dotted line with a suitable tool
and remove the
(cross-hatched).
section below the heater
INTERIOR 23 - 389