Chrysler 2005 Crossfire SRT6 Service Manual page 3396

21 - 326 AUTOMATIC - NAG1 SERVICE INFORMATION
3. Lubricate the pump gears with transmission fluid
and place in the pump housing. Insert the pump
gear (1) so that the chamfer (arrow) points towards
the pump housing.
OUTPUT SHAFT BEARING
REMOVAL
1. Raise and support vehicle.
2. Remove the propeller shaft. (Refer to 3 - DIFFER-
ENTIAL & DRIVELINE/PROPELLER SHAFT -
REMOVAL).
3. Place the transmission in the PARK position before
attempting to remove the output shaft nut.
4. Remove the output shaft nut holding the propeller
shaft flange to the output shaft.
5. Remove the propeller shaft flange.
6. Remove the transmission rear oil seal with a suit-
able slide hammer and screw.
7. Remove the transmission output shaft washer. Be
sure to tag the washer since it is very similar to the
geartrain end-play shim and they must not be inter-
changed.
8. Remove the transmission rear output shaft bearing
retaining ring (1).
ZH