Chrysler 2005 Crossfire SRT6 Service Manual page 3297

ZH
15. Slide the collar (3) on Special Tool 9082 (1) down-
ward over the fingers of the tool (4).
16. Remove the output shaft bearing (3).
17. Remove the geartrain end-play shim from the out-
put shaft. Be sure to tag the shim since it is very
similar to the output shaft washer and they must
not be interchanged.
18. Remove the bolts holding the transmission hous-
ing to the torque converter housing from inside
the converter housing.
19. Stand the transmission upright on the converter
housing. Be sure to use suitable spacers between
the bench surface and the torque converter hous-
ing since the input shaft protrudes past the front
surface of the housing.
20. Remove the remaining bolts holding the transmis-
sion housing to the torque converter housing.
21. Remove the transmission housing from the torque
converter housing.
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 227