Chrysler 2005 Crossfire SRT6 Service Manual page 3171

ZH
(P0715) N2 INPUT SPEED SENSOR CIRCUIT (CONTINUED)
2.
CHECK FOR CURRENT DTC
Note: If the TCM detects and stores a DTC, the TCM also stores
the engine/vehicle operating conditions under which the DTC was
set. Some of these conditions are displayed on the DRB III at the
same time the DTC is displayed.
Note: Before erasing stored DTCs, record these conditions.
Attempting to duplicate these conditions may assist when check-
ing for an active DTC.
Turn the ignition on.
With the DRB III , erase Transmission DTCs.
Note: It maybe necessary to road test the vehicle for this DTC to
set.
With the DRB III , read Transmission DTCs.
Did this DTC set again?
Yes >> Go To 3
No >> Go To 11
3.
SENSOR SUPPLY VOLTAGE CIRCUIT OPEN
Turn the ignition off.
Disconnect the TCM C2 harness connector.
Disconnect the Transmission Solenoid Assembly harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Sensor Supply Voltage circuit from the
TCM C2 harness connector to the Transmission Solenoid Assembly
harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 4
No >> Repair the Sensor Supply Voltage circuit for an open.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
NAG1 - ELECTRICAL DIAGNOSTICS 21 - 101