Chrysler 2005 Crossfire SRT6 Service Manual page 3244

21 - 174 NAG1 - ELECTRICAL DIAGNOSTICS
(P0850) TRANS TEMP SENSOR - P/N SWITCH CIRCUIT (CONTINUED)
6.
SENSOR GROUND CIRCUIT SHORT TO OTHER CIRCUITS
With the ignition off.
Disconnect the TCM C1 harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance between the Sensor Ground circuit and all
other circuits in the TCM C1 and C2 harness connectors.
Is the resistance above 100 kohms for all measurements?
Yes >> Go To 7
No >> Repair the Sensor Ground circuit for a short to other cir-
cuit(s).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
ZH