Chrysler 2005 Crossfire SRT6 Service Manual page 3029

ZH COLUMN 19 - 29
INSTALLATION
1. Install the warning buzzer contact switch (8).
CAUTION: The steering lock and lock cylinder can only be fitted in lock cylinder position 1 . Never turn the
steering lock when the ignition/starter switch is not fitted.
2. Install the washer (3) and the parking lock valve (4).
Note: The ignition switch must not be turned out of position 1 when the ignition/starter switch is not fitted,
otherwise the steering lock is locked permanently.
3. Install the ignition switch (2).
4. Install the clamp (9), press in locking pin to install the steering lock (6) to the steering column.
5. Install the parking lock interlock cable (7).
6. Install the connector from the ignition/starter switch (1).
7. Install the connector from the warning buzzer contact (10).
8. Install the key cylinder.(Refer to 19 - STEERING/COLUMN/KEY/LOCK CYLINDER - INSTALLATION).
9. Install the transponder coil.
10. Install the instrument cluster.(Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER - INSTALLATION).
11. Install the lower instrument panel cover.(Refer to 23 - BODY/INSTRUMENT PANEL/INSTRUMENT PANEL
ASSEMBLY - REMOVAL).