Chrysler 2005 Crossfire SRT6 Service Manual page 3167

ZH
(P0715) INPUT SENSOR OVERSPEED (CONTINUED)
When Monitored and Set Condition
• When Monitored: Whenever the N2 input speed sensor is greater than 0 RPM.
• Set Condition: If the RPM of the N2 or N3 input speed sensor is greater than 7700 RPM.
INTERNAL TRANSMISSION
TRANSMISSION CONTROL MODULE
For a complete Transmission Control Module Circuit Diagram, (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTO-
MATIC - NAG1 - SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
PRE-DIAGNOSTIC CHECK OUT
Note: Low fluid level can be the cause of many transmission
problems. If the fluid level is low, locate and repair the leak then
check and adjust the fluid level in accordance with the Service
Information.
Note: Always perform diagnostics with a fully charged battery to
avoid false symptoms.
With the DRB III , read Engine DTCs. Check and repair all engine
DTCs prior to performing transmission symptom diagnostics.
With the DRB III , read and record all Transmission DTCs.
Note: Check connectors - Clean/repair as necessary. Poor pin to
terminal connections can set DTCs.
Using the wiring diagram/schematic as a guide, inspect the wiring and
connectors. Repair as necessary.
Most DTCs set on start up but some must be set by driving the vehicle such that all diagnostic monitors have run.
Note: Check for any Technical Service Bulletins that may apply.
Perform this procedure prior to Symptom diagnosis.
Continue
Go To 2
NAG1 - ELECTRICAL DIAGNOSTICS 21 - 97
POSSIBLE CAUSES