Chrysler 2005 Crossfire SRT6 Service Manual page 3539

ZH
8. Dismount the upper bead of the tire (1) from the
wheel (2). The upper bead must be fully dis-
mounted from the wheel to remove the tire
pressure transmitter from the inside of the tire.
The bottom bead of the tire does not need to be
removed from the wheel.
9. Pull upward on the tire (1). Reach inside the tire
and remove the pressure sensor/transmitter (3).
INSTALLATION
Note: When installing the tire pressure sensor/transmitter, replace the sealing grommet at the valve stem
base before installing the pressure transmitter in the wheel. Also, be sure that the surface of the wheel that
the grommet seals are against is clean and not damaged.
1. Install the tire pressure sensor/transmitter (1) on
the wheel (2).
2. Install the special sensor mounting nut (3). When
tightening the tire pressure sensor/transmitter nut,
hold the sensor so it does not rotate. Once tight-
ened, the gap between the sensor and the wheel
must be even on both sides as shown. If the sen-
sor/transmitter rotates (clocks), damage to the sen-
sor/transmitter can occur when mounting the tire.
Tighten the nut to 4 N·m (35 in. lbs.).
TIRES/WHEELS - SERVICE INFORMATION 22 - 53