Chrysler 2005 Crossfire SRT6 Service Manual page 3869

23 - 318B EXTERIOR
REMOVAL - DRIVESHAFT
NOTE: Only one side is shown. The procedure is
the same for both sides.
1. Remove the spoiler mounting plate from the vehicle
(Refer to 23 - BODY/EXTERIOR/SPOILER -
REMOVAL).
2. Remove the spoiler motor from the mounting plate
(Refer to 23 - BODY/EXTERIOR/SPOILER -
REMOVAL).
3. Rotate the spoiler wing frame so the roll pin (2) is
parallel to the mounting plate.
4. Using a roll pin punch, remove the roll pin (2).
5. Remove the spoiler wing frame nuts (1), and rotate
the spoiler wing frame (4) up and out from the
driveshaft (3).
6. Release the driveshaft (3) from the spoiler trans-
mission and remove the driveshaft.
REMOVAL - MOTOR BRACKET
1. Remove the spoiler motor (Refer to 23 - BODY/EX-
TERIOR/SPOILER - REMOVAL).
2. Remove the driveshafts (Refer to 23 - BODY/EX-
TERIOR/SPOILER - REMOVAL).
3. Remove the 4 nuts (2) and the spoiler motor
bracket (1).
2005 ZH Service Manual Publication No. 81-270-05036
ZH
05ZH23-318B October, 2004