Chrysler 2005 Crossfire SRT6 Service Manual page 3350

21 - 280 AUTOMATIC - NAG1 SERVICE INFORMATION ZH
ASSEMBLY
1. Install the piston (6) in the outer disc carrier (8). Check the sealing ring (7) and replace if necessary. The
rounded off edges of the sealing ring must point outwards.
2. Insert the spring plate (5). Insert the spring plate (5) with the curvature towards the piston.
3. Mount Special Tool 8900 (9) on the spring plate (5) and clamp until the snap-ring groove is exposed.
4. Insert the snap-ring (4). The collar of the snap-ring (4) must point towards the disc pack (2).
Note: Pay attention to the sequence of the discs. Place new friction multiple-discs in ATF fluid for one hour
before installing.
5. Install the disc spring (3) and the multiple disc pack (2) in the outer disc carrier (8).
6. Insert the snap-ring (1).
7. Measure the K3 clutch clearance.