Chrysler 2005 Crossfire SRT6 Service Manual page 3653

ZH
9711 RIGHT ROTATION RELAY CONTROL CIRCUIT OPEN/SHORT TO B(+) (CONTINUED)
• When Monitored: With the ignition on, the Power Top Control Module (PTCM) continuously senses the
voltage on the Right Rotation Relay Control circuit.
• Set Condition: When the PTCM senses B(+) on the Right Rotation Relay Control circuit.
RIGHT ROTATION RELAY
OPEN RIGHT ROTATION RELAY CONTROL CIRCUIT
OPEN ROTATION RELAY GROUND CIRCUIT
POWER TOP CONTROL MODULE
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.
Diagnostic Test
1.
Read DTCs
Turn the ignition on.
With the DRBIII , read Current DTCs.
Are both Right/Left Relay Control Circuit Open/Short to B(+)
DTCs set?
Yes >> Go To 6
No >> Go To 2
2.
Right Rotation Relay Control Circuit For Short To B(+)
Turn the ignition off.
Disconnect the PTCM C2 harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Right Rotation Relay Control circuit at the
PTCM C2 harness connector.
Is the voltage below 1.0 volts?
Yes >> Go To 3
No >> Repair the Right Rotation Relay Control Circuit for a short
to B(+).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
Possible Causes
CONVERTIBLE TOP 23 - 105