Chrysler 2005 Crossfire SRT6 Service Manual page 3126

21 - 56 NAG1 - ELECTRICAL DIAGNOSTICS
(P0600) ENGINE TORQUE MESSAGE INCORRECT (CONTINUED)
2.
CHECK TO SEE IF ENGINE DTCS ARE PRESENT
Turn the ignition on.
With the DRB III , read Engine DTCs.
Are any performance or BUS related Engine DTCs present?
Yes >> Refer to the Engine - Electrical Diagnostics category and
perform the appropriate symptom.
No >> Go To 3
3.
PCM - ENGINE TORQUE MESSAGE INCORRECT
Turn the ignition off.
Replace and program the Powertrain Control Module. (Refer to 8 -
ELECTRICAL/ELECTRONIC
CONTROL MODULE - REMOVAL).
Turn the ignition on.
With the DRB III , erase Transmission DTCs.
Drive the vehicle performing multiple aggressive upshifts and down-
shifts.
With the DRB III , read Transmission DTCs.
Did DTC (P0600) ENGINE TORQUE MESSAGE INCORRECT set
again?
Yes >> Replace the Transmission Control Module. (Refer to 8 -
ELECTRICAL/ELECTRONIC
REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Test Complete.
CONTROL MODULES/POWERTRAIN
CONTROL MODULES/TRANSMISSION
ZH
CONTROL MODULE -