Chrysler 2005 Crossfire SRT6 Service Manual page 3026

19 - 26 COLUMN
6. Remove the ignition lock cable (1) from electronic
selector lever module by turning it 90° to the left
and then pulling it straight out.
INSTALLATION
1. Install the ignition lock cable (1) to the ignition/
starter switch by sliding it into the retaining slot
until the tabs click.
2. Install the ignition lock cable (1) to the shift lever
assembly by inserting it into the mounting hole and
then turning it 90° to the right.
3. Turn the ignition switch to the OFF/LOCK position.
It should only be possible to move the shift lever
out of the Park position when the ignition switch is
in the ON/RUN position and the brake pedal is
depressed. It should only be possible to remove
the ignition key when the shift lever is in the Park
position and the ignition switch is in the OFF/LOCK
position.
ZH