Chrysler 2005 Crossfire SRT6 Service Manual page 3301

ZH
ASSEMBLY
1. Insert the parking lock gear (5).
2. Install the multi-disc holding clutch B2 (4) in the transmission housing (6).
3. Screw in the bolts (7). Tighten the bolts to 16 N·m (141 in. lbs.).
Note: During the measurement the snap ring (7)
must contact the upper bearing surface of the
groove in the outer multi-disc carrier (8).
Note: Pay attention to the sequence of discs.
Place new friction multi-discs in ATF fluid for one
hour before installing.
4. Insert and measure the spring washer (4) and
multi-disc holding clutch pack B3 (2, 6).
a. Put the multi-discs for multi-disc holding clutch
B3 together in the sequence shown in the illus-
tration and insert individually.
b. Using a feeler gauge, determine the play "L" at
three points between the snap-ring (7) and
outer multi-disc (1). B3 clutch clearance should
be 1.0-1.4 mm (0.039-0.055 in.). Adjust the
clearance as necessary.
c. Adjust with snap-ring (7), if necessary. Snap-rings are available in thicknesses of 3.2 mm (0.126 in.), 3.5 mm
(0.138 in.), 3.8 mm (0.150 in.), 4.1 mm (0.162 in.), 4.4 mm (0.173 in.), and 4.7 mm (0.185 in.).
5. Place the intermediate plate (3) on the converter housing (2) and align.
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 231