Chrysler 2005 Crossfire SRT6 Service Manual page 3304

21 - 234 AUTOMATIC - NAG1 SERVICE INFORMATION
18. Using grease, install both the teflon rings (7) in the groove at the rear of the output shaft so that the joint stays
together.
19. Mount the transmission housing on the torque converter housing.
20. Screw in the bolts through the transmission housing into the torque converter housing. Tighten the bolts to 20
N·m (177 in. lbs.).
21. Measure the end-play between the parking lock gear and the grooved ball bearing in order to select the proper
geartrain end-play shim.
a. Place Special Tool 6311 (1) on the transmis-
sion housing. Using a depth gauge, measure
from the gauge bar (1) to the parking lock gear
(2).
b. Using a depth gauge, measure from the Spe-
cial Tool 6311 (1) to the contact surface of the
output shaft bearing (2) in the transmission
housing.
c. Subtract the first figure from the second figure
to determine the current end-play of the trans-
mission. Select a shim such that the end-play
will be 0.3-0.5 mm (0.012-0.020 in.). Shims are
available in thicknesses of 0.2 mm (0.008 in.),
0.3 mm (0.012 in.), 0.4 mm (0.016 in.), and 0.5
mm (0.020 in.).
d. Install the selected end-play shim.
22. Screw in the bolts through the converter housing
into the transmission housing. Tighten the bolts to
20 N·m (177 in. lbs.)
.
ZH