Chrysler 2005 Crossfire SRT6 Service Manual page 3399

ZH
must point towards the parking lock gear.
b. Install the retaining ring (1). Ensure that the
retaining ring is seated correctly in the groove.
c. Check that there is no play between the bear-
ing (2) and the retaining ring (1) using feeler
gauge.
d. There must be no play between the retaining
ring and the bearing. If the ring cannot be
installed, a thinner ring must be used. If there
is play between the ring and the bearing, a
thicker ring must be installed. Retaining rings
are available in thicknesses of 2.0 mm (0.079
in.), 2.1 mm (0.083 in.), and 2.2 mm (0.087
in.).
2. Install the output shaft washer onto the output
shaft.
3. Install a new transmission rear seal into the trans-
mission case (2) with Special Tool 8902A (1).
4. Install the propeller shaft flange onto the output
shaft.
5. Place the transmission in the PARK position before
attempting to tighten the output shaft nut.
6. Install a new output shaft nut. Tighten the output
shaft nut to 120 N·m (88.5 ft. lbs.).
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 329