Chrysler 2005 Crossfire SRT6 Service Manual page 3141

ZH
(P0700) SENSOR SUPPLY VOLTAGE (CONTINUED)
4.
SENSOR SUPPLY VOLTAGE CIRCUIT SHORT TO GROUND
With the ignition off.
Measure the resistance between ground and the Sensor Supply Volt-
age circuit at the Transmission Solenoid Assembly harness connector.
Is the resistance above 100 kohms?
Yes >> Replace the Transmission Control Module. (Refer to 8 -
ELECTRICAL/ELECTRONIC
TRANSMISSION CONTROL MODULE - REMOVAL).
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Repair the Sensor Supply Voltage circuit for a short to
ground.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
5.
INTERMITTENT WIRING AND CONNECTORS
The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible
intermittent condition.
Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
Wiggle the wires while checking for shorts and open circuits.
Note: Check for any Technical Service Bulletins that may apply.
Were any problems found?
Yes >> Repair as necessary
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> Test Complete.
NAG1 - ELECTRICAL DIAGNOSTICS 21 - 71
CONTROL MODULES/