Chrysler 2005 Crossfire SRT6 Service Manual page 3046

19 - 46 GEAR
2. Remove the lower snap ring (4) from the pitman
shaft.
3. Remove the pitman arm (3) from the pitman shaft.
4. Remove the upper locking ring (2).
5. Remove the pitman shaft seal (1) from the steering
gear housing using a suitable prying tool.
INSTALLATION
CAUTION: DO NOT damage the sealing lip of the
pitman shaft seal when sliding it on over the pit-
man shaft splines.
1. Using Special Tool 9159 Steering Seal Installer (1)
install a new pitman shaft seal into the steering
gear.
2. Install the upper snap ring (2).
3. Remove any oil and grease from the splined sec-
tion of the pitman arm, and the pitman arm shaft.
4. Install the lower snap ring (4).
ZH