Chrysler 2005 Crossfire SRT6 Service Manual page 3441

ZH
INSTALLATION
1. Install the new output flange seal (1) using Special
Tool 9122 Drift (2) and a mallet.
2. Install the output flange (3) and nut. Hold the
flange (3) with Special Tool C-3281 Flange Wrench
(2). Tighten the nut to 180 N·m (133 ft. lbs.).
Note: The Special Tool 9078 has two possible locations for the beveled staking pin. The pin must be
installed in the hole labeled "Transmission" for this operation. This hole is located directly across from the
spring loaded alignment pin.
MANUAL - SERVICE INFORMATION 21 - 371