Chrysler 2005 Crossfire SRT6 Service Manual page 3229

ZH
(P0763) 3–4 SOLENOID CIRCUIT SHORT TO GROUND (CONTINUED)
When Monitored and Set Condition
• When Monitored: Always monitored with system active at each ignition cycle.
• Set Condition: If the TCM detects a short to ground on the solenoid control circuit or a solenoid control circuit
shorted to ground in the TCM.
3-4 SOLENOID CONTROL CIRCUIT SHORT TO GROUND
3-4 SOLENOID CONTROL CIRCUIT SHORT TO ANOTHER CIRCUIT
3-4 SOLENOID
TRANSMISSION CONTROL MODULE
For a complete Transmission Control Module Circuit Diagram, (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTO-
MATIC - NAG1 - SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
CHECK FOR CURRENT DTC
Turn the ignition on.
With the DRB III , read Transmission DTCs.
Is this DTC present?
Yes >> For complete diagnosis of this DTC, refer to (P0763) 3–4
SOLENOID CIRCUIT.
No >> Go To 2
2.
INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set this DTC are not present at this time.
Note: Check connectors — Clean/repair as necessary. Poor pin to terminal connections can set DTCs. Using
the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the
wires while checking for shorts and open circuits.
Note: Check for any Technical Service Bulletins that may apply.
Were there any problems found?
Yes >> Repair as necessary.
Perform NAG1 TRANSMISSION VERIFICATION TEST.
No >> The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for
a possible intermittent condition.
NAG1 - ELECTRICAL DIAGNOSTICS 21 - 159
POSSIBLE CAUSES