Chrysler 2005 Crossfire SRT6 Service Manual page 3446

21 - 376 MANUAL - SERVICE INFORMATION
REAR SECTION HOUSING
DISASSEMBLY
1. Remove the transmission. (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL - REMOVAL).
2. Disassemble the geartrain housing. (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL/GEARTRAIN HOUS-
ING - DISASSEMBLY).
3. Remove the retainer bolt (1).
4. Remove the bearing shell (2), reverse idler shaft (3) with the bearings (4), reverse gear (5) and the washer (6).
5. Drive out the countershaft bearing (8) using a drift punch.
6. Remove the retaining bolts (9), locking plates (10), and the mainshaft bearing (7).
7. Remove the shift shaft bearing (11).
8. Drive out the output flange seal (12).
ASSEMBLY
1. Install a new output flange seal (12) using Special Tool 9123 Drift.
2. Use a suitable deep socket to drive in the shift shaft bearing (11).
3. Install the mainshaft bearing (7), locking plates (10), and retaining bolts (9). Tighten the bolts to 9 N·m (7 ft. lbs.).
4. Drive in the countershaft bearing (8).
5. Install the reverse gear idler shaft (3).
6. Install the bearing shell (2).
7. Install the bearings (4), reverse gear (5), and the washer (6).
8. Align the retainer bolt (1) in the shell and the idler shaft and install. Tighten the bolt to 20 N·m (15 ft. lbs.).
9. Assemble the geartrain housing. (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL/GEARTRAIN HOUSING
- ASSEMBLY).
10. Install the transmission. (Refer to 21 - TRANSMISSION/TRANSAXLE/MANUAL - INSTALLATION).
ZH