Chrysler 2005 Crossfire SRT6 Service Manual page 3835

ZH
6. Install the outer window sealing rail by pressing the
sealing rail onto the window shaft uniformly. Then
install the expanding anchor clip. Install the plastic
cover on the escutcheon, then install the rubber
door seal. Install the chrome cover by installing the
two screws (1).
7. Install the inner window sealing rail by pressing the
sealing rail on the inner door.
8. Adjust the door glass and clean. (Refer to 23 -
BODY/DOOR - FRONT/DOOR GLASS - ADJUST-
MENTS).
9. Install the door trim panel. (Refer to 23 - BODY/
DOOR - FRONT/TRIM PANEL - INSTALLATION).
ADJUSTMENTS
ADJUSTMENT
1. Check the front door adjustment and adjust if nec-
essary. (Refer to 23 - BODY/DOOR - FRONT/
DOOR - ADJUSTMENTS).
2. Remove the door trim panel on the front door.
(Refer to 23 - BODY/DOOR - FRONT/TRIM PANEL
- REMOVAL).
3. Remove the door speaker (1).
4. Remove the door foil from the door.
5. Loosen the nuts from both of the window stop
brackets (2-4) located in the middle portion of the
door.
6. Close the window (5) until it is flush with the front
edge of the door escutcheon.
DOOR 23 - 287