Chrysler 2005 Crossfire SRT6 Service Manual page 3387

ZH
ASSEMBLY
1. Install the piston (2) in the outer multiple-disc carrier (1). Press in the piston using the disc spring (3) and Special
Tool 8900. Place Special Tool 8900 on the disc spring (3) and compress until the groove of the snap-ring (4) is
exposed
Note: Check the vulcanized gasket, replace if necessary.
2. Insert the snap-ring (4).
Note: The collar of the snap-ring must point towards the multiple-disc pack. After installing, check the snap-
ring for correct seat.
3. Insert the disc spring (5) and the multiple-disc pack (6) in the multi-disc holding clutch B1 outer carrier.
4. Insert the snap-ring (7).
Note: Pay attention to the sequence of discs. Place the new friction multiple-discs in ATF fluid for one hour
before installing.
5. Measure the multi-disc holding clutch B1 clearance.
AUTOMATIC - NAG1 SERVICE INFORMATION 21 - 317