Assigning Descriptions To Interfaces - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide
map-list

Assigning Descriptions to Interfaces

You can use the description commands to assign a text description or an alias to an
interface, so that other show commands can display that information.
atm aal5 description
42
Assigning Descriptions to Interfaces
Use to associate the map list with an NBMA interface when configuring static
mapping.
You can issue this command before or after the map-list command without
changing anything.
This command is available in Interface Configuration mode only.
See the map-list command.
Example
host1(config-if)#map-group charlie
Use the no version to remove the association.
See map-group.
Use to create a map list when configuring static mapped NBMA interfaces.
Limit the name of the map list to no more than 31 characters.
You can create multiple map lists; however, you can associate only one map list
with each physical interface.
If a map list contains an entry for a VCD that was previously configured to run
InARP, the map-group command fails. If this is the case, either reconfigure the
circuit with InARP disabled, or remove the entry for that circuit from the map
list.
Example
host1(config)#map-list charlie
Use the no version to remove the map list.
See map-list.
Use to assign a text description or alias to an ATM AAL5 interface.
Use the show atm aal5 interface command to display the text description.
Example
host1(config-if)#atm aal5 description boston01
Use the no version to remove the text description or alias.
See atm aal5 description.