Configuring Static Atm Interfaces Within Vc Subranges; Creating Static Atm Interfaces Within Vc Subranges - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide

Configuring Static ATM Interfaces Within VC Subranges

You can do either of the following on an E Series router:
The following sections describe how to perform these tasks.

Creating Static ATM Interfaces Within VC Subranges

You can configure a static ATM interface with an ATM PVC whose VPI and VCI
addresses fall within an existing bulk-configured VC subrange.
To create a static ATM interface within a VC subrange:
1.
2.
3.
4.
606
Configuring ATM 1483 Dynamic Subinterfaces
No dynamic ATM 1483 subinterfaces can subsequently be created for the
subrange until you restore the administrative state to enabled by using the no
atm bulk-config shutdown command.
Example
host1(config-if)#atm bulk-config test shutdown vc-range 2 2 201 250
Use the no version to enable the specified VC subrange or all subranges in a VC
range.
See atm bulk-config shutdown.
Create a static ATM interface within an existing bulk-configured VC subrange
Create a bulk-configured VC subrange that includes an existing static ATM
interface
Create a bulk-configured VC range that includes one or more VC subranges.
host1(config)#interface atm 0/0
host1(config-if)#atm bulk-config test vc-range 1 3 32 1031
Specify a static ATM 1483 subinterface.
host1(config-if)#interface atm 0/0.2100
Configure an ATM PVC with VPI and VCI values that fall within the bulk-configured
VC subrange. In this example, the VPI value (2) is within the VPI range 1–3, and
the VCI value (100) is within the VCI range 32–1031.
host1(config-subif)#atm pvc 2100 2 100 aal0
Configure the static ATM interface. For example, the mpls-relay command
creates a ATM layer 2 services over MPLS tunnel on the circuit.
host1(config-subif)#mpls-relay 192.168.0.1 2100