Configuring Encapsulation Type Lockout For Pppoe Clients; Differences From Lockout Configuration For Pppoe Over Static Atm - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide
vlan id

Configuring Encapsulation Type Lockout for PPPoE Clients

In configurations with dynamic PPPoE subinterfaces over static PPPoE major
interfaces, you can configure dynamic encapsulation type lockout for the PPPoE
clients associated with a dynamic PPPoE subinterface column. Using this feature
enables you to temporarily prevent the static PPPoE major interface from
autodetecting, accepting, and creating dynamic PPPoE subinterface columns for a
configurable time period.
By default, encapsulation type lockout is disabled for PPPoE clients. To configure a
lockout time range for the PPPoE clients associated with the dynamic PPPoE
subinterface columns on the PPPoE major interface, use the pppoe auto-configure
command with the lockout-time keyword. You can also use the show pppoe
interface lockout-time command to display detailed information about the current
lockout condition for each PPPoE client, and the pppoe clear lockout interface
command to clear (reset) the lockout condition for an individual PPPoE client.
For illustrations of the interface stacking in dynamic PPPoE over static PPPoE
configurations, see Figure 47 on page 534, Figure 48 on page 536, Figure 49 on page 537,
and Figure 51 on page 543.

Differences from Lockout Configuration for PPPoE over Static ATM

Table 28 on page 549 lists the important differences between how encapsulation type
lockout works for dynamic PPPoE over static PPPoE configurations and how lockout
works for dynamic PPPoE over static ATM 1483 configurations.
548
Configuring PPPoE Dynamic Interfaces over PPPoE Static Interfaces
Use to specify the VLAN ID.
Use a VLAN ID that is in the range 0–4095 and is unique within the Ethernet
interface.
Issue the vlan id command before any upper bindings are made, such as IP or
PPPoE.
Use the optional keyword untagged to specify that frames be sent untagged.
The keyword is valid only for VLAN ID 0, which can receive tagged frames but
sends out untagged frames.
Example
host1(config-if)#vlan id 400
There is no no version.
See vlan id.