Monitoring Bridge Interfaces - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide

Monitoring Bridge Interfaces

You can use the show bridge interface command to display information for a
specified bridge interface or for all interfaces assigned to a bridge group.
show bridge interface
500
Monitoring Transparent Bridging
Bridge Name of the bridge group for which the MAC address table is
displayed
Address MAC address of the entry
Action Specifies how the bridge group handles this entry: forward or discard
Interface Interface type and specifier on which the entry will be forwarded;
this value does not appear for entries that are discarded
Age Length of time that a dynamic entry has been in the forwarding table;
this value does not appear for static entries
Example
host1#show bridge westford01 table static
Bridge: westford01 MAC Address Table
Address Action
-------------- ----------
1a11.22b2.333c forward
1234.abcd.5678 discard
See show bridge table.
Use to display configuration, statistics, and status information for a specified
bridge interface or for all interfaces assigned to a bridge group.
Field descriptions
BridgeGroup Name of the bridge group to which the interface belongs
Port Number Bridge group port number on which this interface resides
Operational Status Operational status of the physical interface: Up, Down,
LowerLayerDown, NotPresent
Admin Status State of the physical interface: Up, Down
Snmp Link Status Trap Whether SNMP link status processing is enabled or
disabled for the specified bridge interface
Max Learn Maximum number of dynamic MAC addresses that the bridge
group interface can learn
Subscriber Policy Name of the subscriber policy currently in effect for the
bridge group interface
Statistics Displays statistics information for the specified port
Interface Age
------------------- -----
ATM3/3.1 ---
--- ---