Configuring Mpls Over Vlan; Figure 15: Example Of Pppoe/Vlan/Fast Ethernet Stacking Configuration - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

Figure 15: Example of PPPoE/VLAN/Fast Ethernet Stacking Configuration Procedure

Configuring MPLS over VLAN

Copyright © 2010, Juniper Networks, Inc.
host1(config-if)#encapsulation ppp
Assign an IP address and mask.
8.
host1(config-if)#ip address 192.6.129.5 255.255.255.0
(Optional) Configure additional VLAN subinterfaces by completing Steps 3 through
9.
8.
Figure 15 on page 173 illustrates the PPPoE/VLAN/Fast Ethernet stacking, showing two
separate VLAN subinterfaces. One VLAN subinterface has two PPPoE subinterfaces,
and one VLAN subinterface has one PPPoE subinterface.
To configure MPLS over VLAN over an Ethernet interface:
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet port.
1.
host1(config)#interface fastEthernet 4/0
Specify VLAN as the encapsulation method.
2.
host1(config-if)#encapsulation vlan
The VLAN major interface is added.
Chapter 5: Configuring VLAN and S-VLAN Subinterfaces
173