Pppoe Over Ethernet Configurations - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

PPPoE over Ethernet Configurations

To enable a PPPoE service name table for use with a static interface in PPPoE over
Ethernet configurations:
1.
2.
3.
interface fastEthernet
interface gigabitEthernet
interface tenGigabitEthernet
Configure a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet physical
interface.
host1(config)#interface fastEthernet 4/1
Select PPPoE as the encapsulation method on the interface. This command
creates the PPPoE major interface.
host1(config-if)#pppoe
Assign the PPPoE service name table to the PPPoE major interface.
host1(config-if)#pppoe service-name-table myServiceTable1
Use to select a Fast Ethernet interface.
Example
host1(config)#interface fastEthernet 4/1
Use the no version to remove IP from an interface or subinterface. You must
issue the no version from the highest level down; you cannot remove an interface
or subinterface if the one above it still exists.
See interface fastEthernet.
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
For information about specifying the Gigabit Ethernet or 10-Gigabit Ethernet
interface or subinterface, see "interface gigabitEthernet" on page 349 and
"interface tenGigabitEthernet" on page 349 on "interface tenGigabitEthernet" on
page 623.
Examples
host1(config)#interface gigabitEthernet 1/0
host1(config)#interface gigabitEthernet 4/0/1 6.0.0FRS
host1(config)#interface tenGigabitEthernet 4/0/1
Use the no version to remove IP from an interface. You must issue the no version
from the highest level down; you cannot remove an interface or subinterface if
the one above it still exists.
Chapter 10: Configuring Point-to-Point Protocol over Ethernet
Configuring PPPoE Service Name Tables
359