Use By Radius Or L2Tp - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

Table 21: Interface Specifier Format Examples for dsl-forum-1 Keyword (continued)
Interface Example
Gigabit Ethernet interface on
slot 2, port 0 with no VLAN
or S-VLAN subinterfaces
Gigabit Ethernet interface on
slot 4, adapter 1, port 1 with
no VLAN or S-VLAN
subinterfaces
Gigabit Ethernet interface on
slot 2, port 0, subinterface 1
with VLAN ID 5
Gigabit Ethernet interface on
slot 4, adapter 1, port 1,
subinterface 3 with VLAN
ID 10
Gigabit Ethernet interface on
slot 2, port 0, subinterface 1
with S-VLAN ID 5 and VLAN
ID 6
Gigabit Ethernet interface on
slot 4, adapter 1, port 1,
subinterface 3 with S-VLAN
ID 10 and VLAN ID 20

Use by RADIUS or L2TP

Enabling the router to capture and format the PPPoE remote circuit ID sent from the
DSLAM has no effect by itself. To use the PPPoE remote circuit ID value, you must
send it to a RADIUS server, to an L2TP network server (LNS), or to both by doing
one or more of the following:
Internal Router Format
gigabitEthernet 2/0
gigabitEthernet 4/1/1
gigabitEthernet 2/0.1:5
gigabitEthernet 4/1/1.3:10
gigabitEthernet 2/0.1:5-6
gigabitEthernet 4/1/1.3:10-20
Issue the radius override calling-station-id remote-circuit-id command to
substitute the remote circuit ID value for the standard Calling-Station-Id [31]
RADIUS attribute.
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
How Router Translates
Sets adapter to 0
Sets both svlanId and
vlanId to 4096
Uses other values as
supplied
Sets both svlanId and
vlanId to 4096
Uses other values as
supplied
Sets adapter to 0
Ignores subinterface 1
Sets svlanId to 4096
Uses other values as
supplied
Ignores subinterface 3
Sets svlanId to 4096
Uses other values as
supplied
Sets adapter to 0
Ignores subinterface 1
Replaces - (hyphen)
between svlanId and
vlanID with . (period)
Uses other values as
supplied
Ignores subinterface 3
Replaces - (hyphen)
between svlanId and
vlanID with . (period)
Uses other values as
supplied
Format of
dslForum1InterfaceSpecifier
eth 2/0/0:4096.4096
eth 4/1/1:4096.4096
eth 2/0/0:4096.5
eth 4/1/1:4096.10
eth 2/0/0:5.6
eth 4/1/1:10.20
383
Overview