Configuring Traffic Classes On Multiclass Mlppp Interfaces - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

JUNOSe 11.1.x Link Layer Configuration Guide
2.
3.
4.
5.
Related Topics

Configuring Traffic Classes on Multiclass MLPPP Interfaces

You can configure mapping of QoS traffic classes to multilink classes. The best-effort
QoS traffic class is mapped to multilink class 0 by default.
To configure mapping of QoS traffic classes to multilink classes:
NOTE: You must include the best-effort traffic class in the ppp multilink multiclass
traffic-class command, or the command fails.
Related Topics
354
Configuring Traffic Classes on Multiclass MLPPP Interfaces
host1(config)#interface gigabitEthernet 3/0/0
Specify PPPoE as the encapsulation method on the interface.
host1(config-if)#encapsulation pppoe
Create a PPPoE subinterface.
host1(config)#interface gigabitEthernet 3/0/0.10
Specify MLPPP as the encapsulation method on the subinterface.
host1(config-if)#encapsulation mlppp
Enable multiclass MLPPP and specify the number of miltilink classes to create.
host1(config-if)#ppp multilink multiclass multilink-classes 8
Configuring a Dynamic Interface from a Profile in JUNOSe Link Layer Configuration
Guide, Chapter 17, Configuring Dynamic Interfaces
ppp multilink multiclass
Specify the QoS traffic classes to be mapped to the multilink classes.
To map QoS traffic classes to multilink classes in a dynamic profile:
host1(config-profile)#ppp multilink multiclass traffic-class best-effort voice
otherData video
To map QoS traffic classes to multilink classes in a static MLPPP interface:
host1(config-if)#ppp multilink multiclass traffic-class best-effort voice
otherData video
JUNOSe Link Layer Configuration Guide, Chapter 17, Configuring Dynamic Interfaces
ppp multilink multiclass traffic-class