Cat (Cable And Antenna Test) Mode - Keysight A Series User Manual

Keysight Handheld Analyzers
N99xxA User's Guide
3

CAT (Cable and Antenna Test) Mode

IMPORTANT! For CAT and NA modes, limit lines do not apply
where F1 = F2.
In this Chapter
"Measurement Selection" on page 61
"Quick Settings Table" on page 62
"Frequency Range" on page 63
"Scale Settings" on page 63
"Averaging" on page 64
"Smoothing" on page 65
"Single or Continuous Measure" on page 65
"Resolution (Number of Data Points)" on page 66
"Sweep Time" on page 66
"Output Power" on page 67
"Interference Rejection" on page 68
CAT Mode is typically used to test an entire
transmission system, from the transmitter to the
antenna. This process is sometimes referred to as
Line Sweeping.
CAT Mode is similar to NA (Network Analyzer)
Mode. Learn more in the Supplemental Online
Help:
https://edadocs.software.keysight.com/kkbopen/fi
eldfox-manuals-firmware-software-and-product-s
upport-589310103.html (via FieldFox Manuals,
Firmware, Software and Product Support).
CAT Mode Distance to Fault measurements are
discussed in Chapter 4, "DTF (Distance to Fault)
Measurements.".
59