Keysight A Series User Manual page 243

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
How to Set Up EMF Settings (Requires EMF (Option 358), GPS (Option 307), and SA
Mode (Option 233–Mixed Analyzers))
4. Enabling the imported USB antenna factors and Cable factors:
Figure 9-20 EMF Axis Select [N] Softkey – With the X–Axis Dipole Selected
Keysight N9927-90020 User's Guide
— Optional: Press Antenna Axis
for default operation. When AUTO is selected the application (e.g.,
Channel Power or OTA) controls the axes and switches as needed.
With the AUTO setting, all antenna elements (X, Y, and Z) are OFF.
This softkey is only active when Antenna Select is set to Tri Axial.
— Press Back > Back
a. Verify that the Channel Power measurement is set: Press Measure 1
> Channel Measurements
b. To enable the Triaxial antenna for EMF: Press Meas Setup 4 >
Off EMF Triaxial [OFF]
>
With Sum All, the field strength from all three axes is summed and
displayed. The RF measurements are switched between the three
different antennas (three dipoles), and the resulting summation of
the total power collected, and averaged.
Alternatively, you can select either of three axes to individually
measure the field strength in the one direction.
c. Else, to manually set one of the triaxial antenna's three axes to
individually measure the field strength in one direction.
i. Press Meas Setup 4 >
ii. Select a single
uncorrected use. [X, Y, or Z] is displayed to indicate which
one of the X/Y/Z dipole axes is enabled. If for example the
X axis has been selected in the System > Utilities > EMF
Antennas menu, then Antenna Axis [X] is displayed to
indicate the X axis measurement (i.e., this uncorrected
manual mode is typically used when no EMF Option 358 is
installed). Refer to
d. Modifying the Amplitude Correction Selection:
Press Scale/Amptd >
— Amp Corr Select [Triaxial XYZ]
following:
— Default
(Default – when no Tri Axial antenna is detected).
— Src/Rcvr Split
source side antenna measurements.
the antenna axis should be set to Auto
to exit the USB Antenna softkey menu.
> Channel Power
Sum All
>
EMF Off EMF Axis Select [OFF]
>
Axis X, Axis Y, or Axis Z
Figure 9-20. See also step
More Corrections
>
- then choose one of the
Receiver side only antenna measurements
to work with non-triaxial receiver and
EMF
then
antenna dipole for
.
f
More then
>
243