Overview Of Softkey Menus - Keysight A Series User Manual

Noise Figure Mode (Option 356 – CPU2 Only)
How to Define a Noise Figure Measurement
6. Perform a Receiver Calibration: (Cal >
7. Enter DUT setup type: Meas Setup >
8. Run a User Calibration (i.e., If you are using an external preamp).
9. Use Measure to select the type of noise figure measurement:
10.Use Meas Setup >

Overview of Softkey Menus

This sections describes the Noise Figure's Measure, Measure Setup softkeys,
and related sub-menu softkeys.
1. Define a measurement type.
Noise Figure has asymmetrical uncertainty (i.e., log measurement). Noise
Factor and Noise Temperature have symmetrical uncertainty (i.e., linear
measurement). Uncertainty is not displayed for Gain and Y-Factor.
Keysight N9927-90020 User's Guide
prompts).
— Amplifier (default),
— Downconverter,
— Upconverter, or
— Multi-Stage Converter
(Cal >Run User Cal and follow prompts).
— Noise Figure,
— Noise Factor,
— Gain,
— Noise Temperature, or
— Y-Factor
Uncertainty
Uncertainty Contributions:
— Jitter Uncert OFF
— ENR Uncert OFF
— Mismatch Uncert OFF
— User Cal Uncert OFF ON
the current measurement's uncertainty calculations), and
— Then Back > Uncert Bars
a. Select a Measure—choose:
— Noise Figure
— Noise Factor
Run Receiver Cal
DUT > Type
> Uncert Contributions
ON,
ON,
ON,
(applies the current User Cal uncertainty to
to ON.
Specify Noise Figure (default) or
Specify a Noise Factor or
and follow
to Enable/Disable
657