Electromagnetic Interference (EMI) Measurements – Option 361
EMI Measurements Mode Settings
Points
In the EMI measurements mode, the Points softkey is only active when the
Measurement CISPR softkey is set to Fast SA Scan. Otherwise EMI mode
automatically sets the points (Default = 401). Learn more, see
then
Trace Display States (EMI Mode)
For EMI measurements mode this section defines the four trace state
choices for the Fast SA Scan and for CISPR Band Scan, CISPR Zoom Scan,
and APD Statistics choices, it defines the 4th trace display state choices.
Learn more, see
The behavior of EMI mode is similar to SA mode. This section describes the
softkeys that have similar, but also different behaviors than SA mode. Learn
more, refer to
Analyzers).". See also
How to display the Trace States
— Press Trace 6 >
How to set the EMI Traces
When the EMI measurement type is set to CISPR Band Scan or CISPR Zoom
Scan Trace 1, Trace 2, Trace 3 have default values assigned. The trace can be
disabled under the Measure 1 (toggle to enable/disable) or the Trace 6
hardkeys or re-assigned to measure a different value on the trace by using the
Trace 6 hardkey (e.g., you can re-assign trace 1 to measure Quasi-peak or EMI
averaging). These detector choices are inactive when the EMI measurement
type is set to, Fast SA Scan or APD Statistics. (i.e., APD statistics does not use
detection; it uses inputs. Refer to
Softkeys" on page 341
page
340
—
APD Dwell Time
APD Statistics.) Sets the time to acquire statistics each cycle, and
Trace Points (control grayed out) are derived from the total Amplitude
range displayed on the X axis.
"Points" on page
212.
"How to set the EMI Traces" on page
Chapter 9, "SA (Spectrum Analyzer) Mode (Option 233–Mixed
"Marker Trace (IQA and SA Mode)" on page
Default All
their default settings. For EMI mode the defaults are: Trace 1 (PosPeak T1),
Trace 2 (QuasiPeak T2), Trace 3 (EMI Average T3); Trace 4 (Off, but defaults
to Pos Peak).
and
343).
– (Active only when the CISPR Measurement type =
is measurement specific and returns all traces to
"Measure 1 Hardkey – EMI 'Convenience'
"Input – (Trace Input for APD Measurements)" on
Keysight N9927-90020 User's Guide
Chapter 9
and
340.
704.